Smart Extension of Incubation Capacity

01. 6월 2023

Many protocols need multiple incubation temperatures. In crowded labs where temperature devices must be shared this can be a challenge. Either one reserves the devices some days in advance and have them run of different temperatures, or one must wait until one device heats up or cools down in between the steps. But this can be challenging when the protocols are even time sensitive regarding incubation duration. So very creative ways come up to have samples incubated at different temperatures.

During my PhD difficulties already started in a standard heat-shock transformation. I used an ice bucket for the 4 °C steps, even though knowing that the ice bucket not necessarily has or keeps the 4 °C depending on the surrounding temperature. Then I used a thermal mixer for the shock at 42 °C and afterwards I went into the incubation room, sticking my tubes to a sticky pad with additional adhesive film having them mixed at 37 °C for the recovering phase. A very annoying process I had to go through multiple times a week.

간단히 보기

Table 1: Recommended devices during heat-shock transformation protocol steps

Protocol step	Temperature	Mixing	Device
Incubation of vector with competent cells	4 °C	no	IsoTherm System^®
Heat-shock	42 °C	no	SmartExtender on ThermoMixer^® C
Recovering of cells	37 °C	yes	ThermoMixer^® C

간단히 보기

A smarter option is to have a SmartExtender that fits your thermal mixer and takes e.g., 12 additional 1.5 mL tubes. Ideally you can program a second temperature. Like this you can incubate samples in the SmartExtender, let’s say at 42 °C and mix/incubate samples at 37 °C at the same time. So, heat-shock of multiple samples can be done by just putting tubes from heat zone (42°C) to recover zone (37°C) on the ThermoMixer ® C without walking around and loosing time.

Or you can incubate samples at two different temperatures, 15 °C in the block and 28 °C in the SmartExtender. Either for one, or two different protocols, or persons working in the lab. Or you choose to use a plate and tubes…whatever you need, you can incubate two different samples at two different temperatures. Basically, you can have an incubation device and a thermal mixer in one.

Only open question: How to reliably keep 4 °C? Well, here we recommend an ice-free IsoTherm System ® of which the block for holding samples is cooled in the fridge and then placed in a polystyrene bucket. This system keeps the temperature more reliable, contamination reduced and drop-free compared to ice.

간단히 보기